PressurePro RV 10 Sensor Tire Pressure Monitor System

Our Most Popular Tire Pressure Monitor System for Recreational Vehicles.

Most Motorhomes pulling a car have 10 tires. This system is perfect. 

No tools are necessary to install the PressurePro Tire Pressure Monitoring System and the system is so easy to operate. Simply screw the wireless air pressure Sensor (cap) onto the valve stem replacing the valve stem cap. Plug the Monitor into the vehicle's lighter accessory or other 12v receptacle in the vehicle. Position the monitor inside your RV where reception is best, program the Sensors, and your system is ready to go! It is that easy! Your new system will display current tire pressure as well as alerting to low tire pressure with both a visual and audible warning. The Sensors constantly read the tire pressure and transmit low-pressure readings immediately when they occur. When tire pressure is low, the Monitor identifies the low tire position with a flashing light on that location and an audible alarm to alert to low pressure for increased tire safety and tire blowout prevention.

Don't be confused by other sites that make you figure out each component to order. Our PressurePro kits are designed to keep the ordering process simple for you.

We offer FREE Shipping on any system ordered. Call today if you have any questions:  877.231.1682.

This kit includes:

Monitor,

10 Sensors,

Velcro Pads,

Power Cord,

3-1/2" Whip Antenna,

Complete installation/operating instructions.

(Monitors will only display the wheel positions that have Sensors.)

Our Price $690             

 Can I monitor both the RV and the towed vehicle tires?

This 10 sensor PressurePro system can monitor just the RV, or just the towed vehicle, or both. Sensors can be added on to suit one's needs. Some cars already have another tire pressure monitoring system ("TPMS") on them, but PressurePro has the advantage of reading tire pressures from inside the motorhome while the car is being towed. PressurePro will not interfere with other TPMSs.

PressurePro has a button on the Monitor that is labeled "F/B"--meaning Front or Back. with sensors on both the RV and the car, one might, on occasion, want to just drive the RV without the car, maybe to take to their RV Dealer for maintenance. The F/B button has 3 pushes to it: one push will turn off the lights on the Monitor for the car, temporarily stopping its scan of the car wheels; the second push will turn off the lights for the RV, temporarily stopping its scan of the RV; and the third push will connect the RV and car lights so the Monitor will scan the tire pressures on both vehicles.

PressurePro is versatile, in that one can take the Monitor from the RV, and plug it into the cigarette receptacle of the car, thus using it for a day trip or whenever the RV is not in use. The F/B button should be pressed until just the lights for the car are activated, so the Monitor will only be scanning for the tire pressures of the car.

The Sensors can also be taken off and put on any other vehicle, such as a truck/SUV and a boat trailer, horse trailer, etc. Putting them on another vehicle in their same respective locations (front left to front left, front right to front right etc.) will eliminate the need to reprogram the Monitor. However, it would only take a few minutes to reprogram if that is preferred